bind a tape drive into a loader manually

NovaBACKUP Network 14
Last Updated: Oct 26, 2012 09:46AM PDT

If NovaNET cannot manually bind a Tape Drive into a Loader, it may be possible to bind manually.
To perform this action:
 

  1. Close NovaNET Backup and stop the NovaNET service.
  2. Open the nnconfig.ini file (located in [Install_Path\config], by default).
  3. In nnconfig.ini add the following section:

[Logical name of loader as it appears in application exactly]

Device-0=logical name of device as it appears in application exactly
  •  Save this file, and open NovaNET Backup.
  • The device should now correctly show as bound to the loader.


 NOTE:
This instruction works with the NovaNET v11, for Version 13 (NovaBACKUP Network) it has not been tested.
These names MUST be entered EXACTLY as they are shown in the software, including any Serial Number information.

  

NovaCare Status

NovaStor Support

Contact Us

  • E-Mail NovaStor Support

    Click Here to submit your case to the NovaStor Support Team.

  • Phone Support

    If you have NovaCare Support you can call our support line:

    US Support:
    Call +1(805) 409-3140
    Press 2 for Technical Support
    Monday through Friday
    8am - 5pm PST

    EMEA Support:
    Call +49 (40) 63809 - 989
    Monday through Friday
    9am - 5pm CET (GMT+1)

TeamViewer